NOTE: Due to product and material shortages we are currently experiencing extended order processing and shipping times.
Dana 44 Crossover/High Steer Arm, RH

Dana 44 Crossover/High Steer Arm, RH

Dana 44 and Corporate 10 Bolt Steering Arm Cones, Set of 3

Dana 44 and Corporate 10 Bolt Steering Arm Cones, Set of 3

Dana 44 High Steer Arm, LH

As low as $135.00
SKU
Dana 44 High Steer Arm, LH

Billet steel.

Setup for crossover steering alone, as well as high steer.

Mounting holes for 3 stud (stock) or 4 stud (aftermarket) knuckles.

Tie rod hole is cut at a 10 degree angle to account for the ball joint axis, this makes the mounting surface level with the ground.  

 

Do you know what taper you have?

On our kits we like to use the Tie rod end taper ends because they are stronger and can handle angles better. Not all crossover kit use this end and may have Drag link end taper. Both ends are considered "GM 1 Ton" but mismatching the two can lead to unsafe use. 

The way to find out what taper you have is to measure with a caliper. It can be difficult to read since it is a taper but themeasurement does not need to be precise, just close to these readings:

TRE taper .660” small side .755” large side
DLE taper .700” small side .787” large side

Here we are measuring from the large end of the taper:

Drag link end:

Tie rod end:

Here we are measuring from the small end of the taper:

Drag link end:

Tie rod end:

This can be done on either pitman arms or steering arms to see what taper you have.